------------------------ MS-DOS v6.22 Help: Pause --------------------------
<Notes> <Examples>                                                   <Index>
----------------------------------------------------------------------------
 
                                   PAUSE
 
Suspends processing of a batch program and displays a message that prompts
the user to press any key to continue. You can use this command only within
batch programs.
 
Syntax
 
    PAUSE
 
                                      ***

<Syntax> <Examples>
----------------------------------------------------------------------------
 
                                PAUSE--Notes
 
Prompting the user to continue the program
 
MS-DOS displays the following message in response to the PAUSE command:
 
    Press any key to continue . . .
 
Dividing a batch file into sections
 
If you press CTRL+C to stop a batch program, MS-DOS displays the following
message:
 
    Terminate batch job (Y/N)?
 
If you press Y (for yes) in response to this message, the batch program ends
and control returns to the operating system. Therefore, you can insert the
PAUSE command before a section of the batch file you may not want to
process. While PAUSE suspends processing of the batch program, you can press
CTRL+C and then Y to stop the batch program.
 
                                      ***

<Syntax> <Notes>
----------------------------------------------------------------------------
 
                               PAUSE--Example
 
Suppose you want a batch program to prompt the user to change disks in one
of the drives. To do this, you might create the following file:
 
    @echo off
    :begin
    copy a:*.*
    echo Please put a new disk into drive A
    pause
    goto begin
 
In this example, all the files on the disk in drive A are copied to the
current directory. After the displayed comment prompts you to place another
disk in drive A, the PAUSE command suspends processing so that you can
change disks and then press any key to resume processing. This particular
batch program runs in an endless loop. The GOTO BEGIN command sends the
command interpreter to the begin label of the batch file. To stop this batch
program, press CTRL+C and then Y.
 
                                      ***

----------------------------------------------------------------------------
<Top of page>
Last update: June 14, 2000 06:20 EST by -vjf-
Content © 1997 Microsoft Corporation
All else © 2000 Vernon J Frazee
Counter